adabas.blogg.se - Gl854g usb hub pid

Downstream ports support HS, FS, and low-speed (LS) traffic.

Upstream port supports both high-speed (HS) and full-speed (FS) traffic.

Compliant to USB Specification Revision 2.0.

*TT (transaction translator) is the main traffic control engine in an USB 2.0 hub to handle the unbalanced traffic speed between the upstream port and the downstream ports. For the detailed configuration methods, please refer to the following table. Number of downstream ports and non/removable downstream port can be configured by different ways, such as EEPROM, SMBUS or I/O strapping. GL850G-60 is a full function solution which supports both Individual and Gang (4 ports as a group) mode for power management (Individual mode is only available in QFN28 package). are easily achieved by programming the external EEPROM or SMBUS mode. The complicated settings such as PID, VID, and number of downstream ports settings…etc. GL850G-60 provides better design flexibility for customers. Default settings in the internal mask ROM is responded to the host without having external EEPROM. Firmware of GL850G-60 will control its general purpose I/O (GPIO) to access the external EEPROM and then respond to the host the customized PID and VID configured in the external EEPROM. GL850G-60 embeds an 8-bit RISC processor to manipulate the control/status registers and respond to the requests from USB host.

GL850G-60 integrates both 5V to 3.3V and 3.3V to 1.8V low dropout voltage regulator into single chip, therefore no external LDO required. GL850G-60 provides multiple advantages to simplify board level design that help achieving lowest BOM (Bill of Material) for system integrator. GL850G-60 has proven compatibility, lower power consumption figure and better cost structure above all USB2.0 hub solutions worldwide.

GL850G-60 inherits Genesys Logic’s cutting edge technology on cost and power efficient serial interface design. GL850G-60 is Genesys Logic’s advanced STT hub solutions which fully comply with Universal Serial Bus Specification Revision 2.0.